Image result for stud finder

Finding the stud on a wall to hang something is one of the most challenging tasks to do. You can use mollies or butterfly anchors to find the stud, but those methods do not work very well and can cause damage to the wall. And all these methods are outdated to be used. 

Modern methods of locating a stud

The easiest and the most innovative way are to use a stud finder, but they are not accurate every time. If you found the best stud finder to it will sometime also give the wrong result. Here are some tips for using a stud finder and for getting a general idea of where a stud should be so that you can better know that the viewfinder is accurate or not.

  • There is always a stud at the corner of the wall, and within 1.5 inches of a door jamb — all you have to follow the measurement.
  • There is always a stud place directly to one side or the other side of an electrical outlet or the light switch or fans switch.
  • The study will be at a spacing of 12 inches on center or 16 inches on center if the walls are exterior.
  • The stud spacing will be spaced 24 inches on center or 16 inches on center if you have an interior wall.


By reading and following these guidelines, you can have a good idea of that where is the location of stud exists, even without using any stud finder. Using a tiny drill bit before drilling and hammering is the best way to double-check for a stud. After you located the stud, use a tiny drill bit like 1/32 to make a small hole inside the stud of the wall. If bit moves freely after ½ inch, there is no stud in that wall. By using this tiny bit, you can drill many small holes in the wall for finding a stud, and the gaps cannot be noticed easily. After you found the perfect stud for your hanging, drill and fix the nail in the hole.